Technical data

604 Chapter 20
W-CDMA or W-CDMA (with HSDPA) Over Air
Optional W-CDMA or W-CDMA (with HSDPA) Over the Air Measurement
Settings
W-CDMA or W-CDMA (with HSDPA)
Over Air
Setting the PICH Parameters
The PICH (Paging Indicator Channel) Setting allows you enable PICH and
designate the channel number. The PICH settings help the test set to determine
which channel is the PICH channel. Once the test set has identified this channel, it
can perform the delta power measurements for this channel and display them to you.
2 [S-CCPCH] This key displays the current Spread Factor,
selected channel, and Enable /Disable status.
3 On [S-CCPCH Enable]
select
On or Off.
Each time you press this softkey, the selected
option changes.
4 Set the Spread Factor.
a. [Spread Factor]
b. [4], [8], [16], [32],
[64], [128], or [256].
5 Set the channel.
a. [Channel]
b. Enter the channel
number using the
numeric keypad.
c. [Enter]
Always enter the channel number even if you have
set Units to Freq.
Step Notes
1 [Setup]
2 [PICH] This key displays the current Spread Factor,
selected channel (in parenthesis), and Enable
/Disable status.
3 On [PICH Enable]
select
On or Off.
Each time you press this softkey, the selected
option changes.
[Spread Factor] is grayed out and unavailable
because the spread factor is fixed at 256.
Step Notes