Technical data

64 Chapter 3
1xEV-DO Analyzer and Over Air Test
Performing a Basic 1xEVDO Transmitter Measurement
1xEV-DO Analyzer and Over Air
Test
12. On [PN Offset] select Auto
or
Manual.
The test set defaults to Auto mode. The other
choice is Manual.
• In Auto mode the test set finds the PN
Offset and displays the value in the metrics
display at the bottom of the screen. The
Time Offset is derived from the PN Offset
that has been found.
• In Manual mode you must enter the PN
Offset, which appears in the metrics
display. The Time Offset is derived from
the entered PN Offset.
13. Connect to the access
network.
Connections for out of service 1xEVDO measurements with GPS receiver as
timing reference. This setup is typically used when setting or measuring Tx
Power Out Levels.
Step Notes