Technical data

Chapter 23 655
Returning the Test Set for Service
Returning your Base Station Test Set for Service
Returning the Test Set for Service
2 Caution: Cover all front and
rear panel connectors that were
originally covered when you
first received the system.
3 Pack the system in the original
shipping containers. Original
materials are available through
Agilent Technologies office.
See step 4 for more
information.
4 Wrap the system in anti-static
plastic to reduce the possibility
of damage caused by
electrostatic discharge.
For systems weighing less than 54 kg (120
lbs.), use a double-walled, corrugated
cardboard carton of 159 kg (350 lbs.) test
strength.
The carton must be large enough to allow 3
to 4 inches on all sides of the system for
packing material, and strong enough to
accommodate the weight of the system.
Surround the equipment with 3 to 4 inches
of packing material, to protect the system
and prevent it from moving in the carton. If
packing foam is not available, the best
alternative is S.D-240 Air Cap™ from
Sealed Air Corporation (Commerce,
California 90001). Air Cap looks like a
plastic sheet filled with air bubbles. Use
the pink (anti-static) Air Cap to reduce
static electrical damage. Wrapping the
system several times in this material will
protect the system and prevent it from
moving in the carton.
5
Seal the carton with strong
nylon adhesive tape and mark
it “FRAGILE, HANDLE
WITH CARE”.
Step Notes