Technical data

Chapter 3 71
1xEV-DO Analyzer and Over Air Test
Performing a Basic 1xEV-DO Over Air Measurement
1xEV-DO Analyzer and Over Air
Test
Performing a Basic 1xEV-DO Over Air Measurement
Step Notes
1
Mode If your test analyzer is already performing a
1xEV-DO Transmitter measurement, you can
switch quickly to 1xEV-DO Over the Air
measurements by pressing [Display] and then
switching OTA PN Scanner On. If you do this,
you can omit steps 2 and 3, and skip straight to
Step 4.
2 [Over Air] See above.
3 [1xEV-DO Over Air] See above.
4[Chan Std]
5 Select the channel standard
you want using the up and
down arrow buttons.
6 [Select]
7 On [Units] select
Chan or
Freq.
Each time you press this softkey, the selected
option changes.
8 [Channel] or [Frequency] • If you selected
Chan in the previous step,
select [Channel].
• If you selected
Freq, select [Frequency].
9 Enter the channel or
frequency using the
numeric keypad.
10 [Fwd] Selects the forward 1xEV-DO channel.
11 Verify that on [Fr/Time
Ref]
GPS is selected. If
not, press [Fr/Time Ref],
then press [GPS].