Technical data

Chapter 3 77
1xEV-DO Analyzer and Over Air Test
Optional 1xEV-DO Tx and Over Air Analyzer Measurement Settings
1xEV-DO Analyzer and Over Air
Test
Optional 1xEV-DO Tx and Over Air Analyzer
Measurement Settings
You can change several optional measurement parameters in the 1xEV-DO Tx and
Over Air Analyzer:
• “Setting the Channel or Frequency Step” on page 77
• “Setting the PN Offset” on page 79
• “Setting the PN Increment” on page 79
• “Setting the Active Channel Threshold Level and Auto Threshold Level” on
page 80
• “Setting the Frequency/Time Reference” on page 81
• “Setting Units” on page 82
• “Setting the 1xEV-DO Transmitter Reference Level” on page 82
• “Setting Measurement Time” on page 83
• “Setting Measurement Offset” on page 84
• “Setting the Slot Threshold Level” on page 85
• “Setting the CDP Type” on page 85
• “Setting the Pilot Dominance Limit” on page 86
• “Setting the Multipath Power Limit” on page 87
• “Setting the PN Scanner Sensitivity” on page 87
• “Setting Average, Sweep, and Restart” on page 88
• “Adding a Marker” on page 90
• “Setting the Pass/Fail Limits” on page 92
Setting the Channel or Frequency Step
You can set the channel or frequency step so you can quickly increment to the next