Technical data

Chapter 3 89
1xEV-DO Analyzer and Over Air Test
Optional 1xEV-DO Tx and Over Air Analyzer Measurement Settings
1xEV-DO Analyzer and Over Air
Test
The reported averages for the following measurements will only be updated when
non-idle slots are identified within the update interval. If no non-idle slots are
identified, the average values reported will be from the previous update interval:
• Non-idle Power
NOTE The Idle Slots metric itself is always averaged even if averaging is switched Off. It
represents the average of all the captures since the measurement was started. You
can reset the Idle Slots metric by changing a parameter, or by using the
Restart key.
When you switch averaging On, it is averaged in the same way as the other metrics.
To set averaging:
NOTE These two steps can be performed in any order. However, if you turn averaging on
and a large number of averages has previously been set, there may be a delay before
you can change number of averages.
Using Restart
When you have averaging turned on, you can restart the averaging by pressing the
Restart menu key. This restarts the averaging for running average in either
Continuous or Single sweep mode.
Step Notes
1 Set the number of averages.
a. [Average]
b. Enter the number of averages
using the numeric keypad.
c. [Enter]
2 Set averaging On or Off.
a. [Average/Sweep]
b. [Averaging]
c. [Off] or [On]