Technical data

96 Chapter 3
1xEV-DO Analyzer and Over Air Test
Optional 1xEV-DO Tx and Over Air Analyzer Measurement Settings
1xEV-DO Analyzer and Over Air
Test
Setting the Measurement Time Offset Limits
Step Notes
1 On [Time Offset Limits]
select
On or Off.
Enables you to toggle the measurement limits
function On (active) and Off (inactive).
• If set to
On, the displayed time offset metrics
will change from blue to red (fail), or to green
(pass), and will indicate either “P” (pass) or “F”
(fail). If the measured values exceed the upper
limit or falls below the the lower limit, the
words ‘ALL PASS’ in the bar at the bottom of
the screen will change to ‘FAILURE’.
• If set to
Off, the time offset value will be
displayed in blue. The bar at the bottom of the
screen will indicate measurement in progress.
2 Set the upper limit.
a. [High Limit]
b. Enter the number on
the numeric keypad.
c. [μsec]
3 Set the lower limit.
a. [Low Limit]
b. Enter the number on
the numeric keypad.
c. [μsec]