Instruction manual

126 Chapter 4
Troubleshooting
To configure the A20 Digital Motherboard and BIOS
Change Supervisor Password
A password needs to be entered to execute the BIOS setup utility. If a password has not
been assigned in the E5061A/E5062A, set the password using this BIOS setup utility as
follows.
a. Select "Security" using keys at the BIOS Setup Utility main menu and press
key.
b. Select “Set Supervisor password” using keys and press key.
c. Enter the password of "e506xa". Never set another password.
d. Press key.
e. If a message of "New supervisor password installed. Press any key to continue" is
displayed, press key.
Save & Exit Setup
When you want to change and save a BIOS option, Select "Exit" using keys at the
BIOS Setup Utility main menu and press key. Select “Save CMOS to Flash” using
and press key. Then select “Exit Saving Changes” using and press
key. A message of "SAVE to CMOS and EXIT (Y/N)?" is displayed. Press and
keys.
The BIOS setup utility is closed after the current settings are saved.
Exit Without Saving
If you cancel the changes in the BIOS option settings, select "Exit Discarding Change"
using keys at the Exit Menu and press key. Then, a message of "Quit
Without Saving (Y/N)?" is displayed. Press and keys.
The BIOS setup utility is closed without saving the current settings.