Instruction manual

Chapter 1 15
General Information
Organization of Service Guide
1. General Information
Organization of Service Guide
Tabs are used to divide the major chapter and appendix of this manual. The contents of
each chapter and appendix in this manual is as follows;
Chapter 1 , “General Information,”
The Service Guide is a guide to servicing the E5061A/E5062A RF Network
Analyzer. The guide contains information requisite to do performance tests,
adjustments, troubleshooting, and repairs.
Chapter 2 , “Performance Tests,”
This chapter provides information on how to verify the E5061A/E5062A
performance.
Chapter 3 , “Adjustment,”
This chapter provides the adjustment information for the E5061A/E5062A to ensure
that it is within its specifications. The adjustment must be performed Agilent’s
qualified service personnel. If you need the adjustment for your E5061A/E5062A, it
should be sent to the nearest Agilent Technologies service office.
Chapter 4 , “Troubleshooting,”
This chapter provides the procedure to isolate a faulty assembly in the
E5061A/E5062A.
Chapter 5 , “Replaceable Parts,”
This chapter contains information for ordering replacement parts for the
E5061A/E5062A.
Chapter 6 , “Replacement Procedure,”
This chapter provides procedure for removing and replacing the major assemblies in
the E5061A/E5062A.
Chapter 7 , “Post-Repair Procedures,”
This chapter lists the procedures required to verify the E5061A/E5062A operation
after an assembly is replaced with a new one.
Appendix A , “Manual Changes,”
This appendix contains the information required to adapt this manual to versions or
configurations of the E5061A/E5062A manufactured earlier than the current printing
date of this manual. The information in this manual applies directly to
E5061A/E5062A units with the serial number that is printed on the title page of this
manual.
Appendix B , “System Recovery,”
This appendix describes how to recover the operating system (Windows 2000) when
the operating system has been damaged.
Appendix C , “Firmware Update,”