Instruction manual

Chapter 7 197
Post-Repair Procedures
Post-Repair Procedures
7. Post-Repair Procedures
A24 GPIB Card
No adjustment needed “To Check the GPIB” on page 116
A27 HDD
Perform “HDD” (Hard Disk Drive) in
Spot Adjustment of the program.
Calibration of the Touch Screen (for opt.
016)
Inspect the Booting Process
A28 FDD
No adjustment needed “To Check the FDD” on page 111
A50 Power Supply
Assembly
No adjustment needed Inspect the Booting Process
A51 LCD
Not adjustment needed Inspect the Booting Process
“To Check the LCD” on page 110
Touch panel (for
Opt. 016)
Calibration of the Touch Screen Inspect the Booting Process
“To Check the Touch Panel (Option 016
only)” on page 110
A52 Inverter Board
No adjustment needed Inspect the Booting Process
Table 7-1 Post-Repair Procedures
Replaced
Assembly or Part
Required Adjustments
Correction Constants (CC)
Verification