Instruction manual

Appendix B 205

System Recovery

B. System Recovery

Procedure to execute the factory recovery function

This section describes how to return the contents of the C drive to the factory state.

NOTE You need the keyboard for this operation.

Step 1. Shut down the E5061A/E5062A.

Step 2. Connect the keyboard to the E5061A/E5062A.

Step 3. Insert the disk for the system recovery into the floppy disk drive of the E5061A/E5062A.

Step 4. Press the standby switch of the E5061A/E5062A to turn it on.

Step 5. When the screen as shown in the figure below appears, press and hold of the

keyboard until this screen disappears.

NOTE After several seconds, the next screen appears automatically even if you do not press any

key, so do not miss it.

If the above message does not appear, the instrument is at fault; contact your local Agilent

customer center listed at the end of this manual or distributor.