Instruction manual

28 Chapter 2
Performance Tests
Instruction for Using the Performance Test Software
Figure 2-2 USB to GPIB Configuration dialog box
If you need to check/change the setting of the USB/GPIB interface after connecting the
USB/GPIB interface, follow these steps:
Step 1. Press .
Step 2. Press
Misc Setup.
Step 3. Press
GPIB Setup.
Step 4. Press
System Controller Configuration.
Step 5. The IO Config dialog box (Figure 2-3) appears. Select (highlight)
GPIB0 hpib7 (1 in
Figure 2-3) and then click the
Edit button (2 in Figure 2-3).
NOTE In the IO Config dialog box, do not click buttons other than specified here or do not change
other settings because doing so may cause serious damage to the functions of the
E5061A/E5062A.