User`s guide

96 Chapter 3
Basic Digital Operation
Using Waveform Markers
10.Press Name and Store.
If you exit the softkey menu shown above without saving the changes, you will be
prompted to confirm exiting without saving. When you see this message at the top of the
softkey menu, you can either press the confirmation softkey or press the
Return hardkey to
return to the softkey menu where you can save your changes.
11.Store the file to the current file name by pressing Enter, or enter a new file name by using
the following steps.
a. Press
Editing Keys > Clear Text.
b. Using the alpha/symbol softkeys and the numeric keypad, enter a new file name.
c. Press the
Enter softkey
12.Press the
Mode Setup softkey to return to the first-level softkey menu.
Toggling Markers As You Create a Waveform Sequence
When you build a waveform sequence, the markers on each segment are toggled to the last
marker operating state (on or off) that was used. You can combine waveform segments to
create a waveform sequence while independently toggling the markers of each waveform
segment. Waveform segments must reside in volatile memory before you can build a waveform
sequence.
In this example, you learn how to toggle markers while building a waveform sequence. If you
have not created waveform segments, complete the steps in the section, “Creating Waveform
Segments” on page 77.
1. Press
Mode > Dual ARB > Waveform Sequences > Build New Waveform Sequence.
Marker
Column
This entry
shows all
markers on.