User`s guide

218 Chapter 8

CDMA Digital Modulation

Storing a Component Test Waveform to Memory

In this section, you will learn how to store the component test waveform.

1. Press Mode Setup hardkey to return to the top-level menu.

2. Perform the following keypress sequence required for your format type.

For CDMA2000 Waveform Format

a. Press

More (1 of 2) > CDMA2000 Define (Multicarrier Define when Multicarrier Off On is On) >

Store Custom CDMA State (Store Custom Multicarrier when Multicarrier Off On is On) > Store

To File.

If there is already a file name occupying the active entry area, press the following keys:

Edit Keys > Clear Text

b. Using the alphabetic menu and the numeric keypad, enter the file name.

c. Press

Enter.

For CDMA Waveform Format

a. Press

CDMA Define (Multicarrier Define when Multicarrier Off On is On) > Store Custom State

(Store Custom Multicarrier when Multicarrier Off On is On > Store To File.

If there is already a file name occupying the active entry area, press the following keys:

Edit Keys > Clear Text

b. Using the alphabetic menu and the numeric keypad, enter the file name.

c. Press

Enter.

Your user-defined CDMA state file is now saved to the signal generator memory.

NOTE The RF output amplitude, frequency, and operating state settings are not

stored as part of a user-defined CDMA state file.