User`s guide

Chapter 12 291
Real Time TDMA Formats
TETRA Framed Modulation
Configuring the RF Output
1. Set the RF output frequency to 1.894880 MHz.
2. Set the output amplitude to 0 dBm.
3. Press
RF On/Off to On.
The user-defined TETRA signal is now available at the signal generator’s RF OUTPUT
connector.
To store this real-time I/Q baseband digital modulation state to the instrument state register,
see “Saving an Instrument State” on page 55.
To recall a real-time I/Q baseband digital modulation state, see “Recalling an Instrument
State” on page 56.