Specifications

Fully Coded 3GPP W-CDMA Personality User’s and Programming Guide 3-5
ESG Family Signal Generators Softkey Reference
Option 200 A
A
Abort Channel Setup
This key immediately stops the channel-coding generation process that
was initiated after pressing the
Apply Channel Setup softkey. This key is
valid for uplink only.
Softkey Location (Uplink):
Mode > CDMA > W-CDMA > Link Up >
Link Control > 1 or 2 > PhyCH Setup > Apply Channel Setup >
Abort Channel Setup
Or: Mode > CDMA > W-CDMA > Link Up > Link Control > 2 >
Config Transport > Transport Channel # 1 to 6 > TrCH Setup >
Apply Channel Setup > Abort Channel Setup
Actual BER
This field displays the actual bit error rate (BER) value being
generated. This value may be different from the desired BER value as
set in the BER field. It is calculated after the
Apply Channel Setup key is
pressed and the error bits are inserted into the data of the transport
channel. To insert the error bits, the Err Insert field must be set to
BER. This data field is on the second page of the table editor.
Data Field Location (Uplink):
Mode > CDMA > W-CDMA > Link Up >
Link Control > 2 > Config Transport > Transport Channel # 1 to 6 >
TrCH Setup > Actual BER
Actual BLER
This field displays the actual block error rate (BLER) value being
generated. This value may be different from the desired BLER value as
set in the BLER field. It is calculated after the
Apply Channel Setup key is
pressed and the error blocks are inserted into the data of the transport
channel. To insert the error blocks, the Err Insert field must be set to
BLER. This data field is on the second page of the table editor.
Data Field Location (Uplink):
Mode > CDMA > W-CDMA > Link Up >
Link Control > 2 > Config Transport > Transport Channel # 1 to 6 >
TrCH Setup > Actual BLER