Specifications

Fully Coded 3GPP W-CDMA Personality User’s and Programming Guide 2-47
ESG Family Signal Generators Using Functions
Option 200 3GPP W-CDMA User Equipment Performance Tests
Table 2-24 Blocking Characteristics Transport Layer Configuration
Parameter Setting
Reference Measurement Setup
1
12.2 kbps (ESG 2)
1
For details, see Table 4-12.
Table 2-25 Blocking Characteristics W-CDMA Baseband Signal Configuration
Parameter Setting(s)
BS Setup Filter: RNYQ
Chip Rate: 3.840000 Mcps
Scramble Code: 0
BBG Data Clock Ext
Phase Polarity Normal
Two Box Setup (Relative Power Mapping)
Enter values as required.
1
W-CDMA Off/On On
1
For detailed information, see “Adjust the Relative Power Mapping” on page 2-14.
Table 2-26 Blocking Characteristics W-CDMA RF Carrier Configuration
Parameter Setting
Frequency
1
2140.0 MHz (ESG 1) (Arbitrary Value)
2150.0 MHz or 2130.0 MHz (ESG 2)
Amplitude
2
−
80.0 dBm (ESG 1) (Arbitrary Value)
−
52.0 dBm (ESG 2)
RF Off/On
3
On (ESG 1)
Off (ESG 2)
Mod Off/On On
1
The frequency of the unwanted signal generated at the output of ESG 2 must be
±
10 MHz
from the fundamental waveform generated at the output of ESG 1.
2
The amplitude of the RF output of ESG 1 is initially set to an arbitrary value (
−
80.0 dBm),
in order to perform a BER verification measurement. After BER verification, the
amplitude will be modified to the required value (−92.7 dBm) in accordance with the
3GPP specification for this performance test.
3
The RF output of ESG 2 remains off until the initial BER verification measurement has
been performed. After BER verification, the RF output of ESG 2 (the interferer) will be
applied to the UE in accordance with the 3GPP specification for this performance test.