Specifications

2-76 Programming Guide
Programming Commands and Examples ESG Family Signal Generators
Using the Example Programs
Using the Example Programs
The example programs are interactive. They require active participation by the operator.
To gain an understanding of the principles without following all of the instructions, read
the “Program Comments” sections to follow the programmed activity.
The GPIB select code is assumed to be preset to 7. All example programs in this section
expect the signal generator’s GPIB address to be decimal 19.
To verify the signal generator’s current GPIB address, press
Utility > GPIB/RS-232 >
GPIB Address.
The active entry area indicates the present GPIB address. If the number displayed is not
19, press
19 on the numeric keypad and then press Enter to set the address to 19.
Now check that the interface language is set to SCPI. Press
Utility > GPIB/RS-232 >
Remote Language. The selected interface language is then shown. If the instrument’s
remote language is not set to SCPI, press
Utility > GPIB/RS-232 > Remote Language > SCPI.