Specifications

Programming Guide 2-85
ESG Family Signal Generators Programming Commands and Examples
Generating a CW Signal, Example Program 4
Program Comments
10 to 120: Title and program description
130: Assigns the signal generator’s GPIB address to a variable.
140: Places the signal generator into LOCAL mode.
150: Resets the signal generator’s parser and clears any pending output from the source.
160: Clears the controller’s display.
170: Sets the signal generator to a defined state for programming.
180 to 190: Sets the frequency to 500 kHz.
200 to 210:
Sets the signal generator’s power level to
−2.1 dBm.
220 to 230: Turns the RF output on.
240: Returns the signal generator to LOCAL mode.
250: Prints a message to the controller’s display.
260: Ends the program.