Specifications

21
This allows the power and response of the mobile phone’s power control
system to be monitored. Figure 12 shows a simulation of the power
response of a mobile phone as would be viewed on a signal analyzer.
Figure 12. Power control display simulation
[Center Frequency = 900 MHz, Mode = cdmaOne, Measure = Waveform(Time Domain), Sweep Time = 30 ms,
Res BW = 2 MHz, Scale/Div = 1.00 dB, Ref Value = 0.00 dBm]
Demonstration example
A demonstration example of a functional test setup is shown in
Figure 13. This example utilizes the ESG Option 201 personality and
an Agilent Technologies E7473A CDMA drive test system. (Note that
the E7473A CDMA drive test system is not part of the ESG Option 201,
but may be purchased separately.) Once configured, the drive test
system is able to monitor the signals generated by the ESG. Details
such as pilot channel power, sync messages, and paging messages may
be observed.
Figure 13. Demo setup example for functional testing
A mobile phone is connected to the drive test system and configured by
defining the hardware project, the mobile phone, and the appropriate
port. For details on drive test configuration, refer to the drive test user’s
guide.
2
5
8
0
3
6
9
#
Agilent ESG
RF Signal Generator
with Option 201
Agilent E7473A
CDMA Drive Test
System