User`s guide

58 Chapter 2

Basic Operation

Using Data Storage Functions

2. Press Save > Select Seq.

The sequence number becomes the active function. The signal generator displays the last sequence

used. Using the arrow keys, set the sequence to 1.

3. Press

Select Reg.

The register number in sequence 1 becomes the active function. The signal generator displays

either the last register used accompanied by the text: (in use), or (if no registers are in use)

4. Press

Save Seq[1] Reg[01].

This saves this instrument state in sequence 1, register 01 of the instrument state register.

5. Press

Add Comment to Seq[1] Reg[01].

This enables you to add a descriptive comment to sequence 1 register 01.

6. Using the alphanumeric softkeys or the knob, enter a comment and press

Enter.

7. Press

Edit Comment In Seq[1] Reg[01].

If you wish, you can now change the descriptive comment for sequence 1 register 01.

After making changes to an instrument state, you can save it back to a specific register by

highlighting that register and pressing Re-SAVE Seq[n] Reg[nn].

Recalling an Instrument State

Using this procedure, you will learn how to recall instrument settings saved to an instrument state

1. Press

Preset.

2. Press the

Recall hardkey.

Notice that the

Select Seq softkey shows sequence 1. (This is the last sequence that you used.)

3. Press

RECALL Reg.

The register to be recalled in sequence 1 becomes the active function. Press the up arrow key

once to select register 1. Your stored instrument state settings should have been recalled.

Deleting Registers and Sequences

These procedures describe how to delete registers and sequences saved to an instrument state

Deleting a Specific Register within a Sequence

1. Press

Preset.

2. Press the

Recall or Save hardkey.

Notice that the

Select Seq softkey shows the last sequence that you used.

3. Press

Select Seq and enter the sequence number containing the register you want to delete.