Specifications

Troubleshooting Plug-in Modules 5-25
$JLOHQW0$996HULHV6HUYLFH*XLGH
Troubleshooting Plug-
in Modules
❏ If ,123PHVVDJHVare displayed for the Blood Analysis module, perform the
following actions. More detailed information relating to the cause of some of the
INOPs can be found in the Blood Analysis Task Window (see Table 5-15 on page 5-
26). Correct the possible cause identified by the INOP message and verify that the
INOP disappears.
❏ If a PHDVXUHPHQWLVXQVXFFHVVIXO or parameters are missing, perform the following
actions:
6WHS 1RWH7KLVVWHSRQO\DSSOLHVIRUFXVWRPHUVZKRSUHVHOHFWHGWKH5HVXOW6HOHFWLRQ!
21LQ&RQILJXUDWLRQ0RGH
Make sure that all parameter results you intended to display are switched on in the
Results Selection Task Window.
If you have already confirmed the measurement, perform a new measurement to
check, if the error still exists. If you haven’t confirmed the measurement yet, the
change will be visible immediately.
6WHS The Task Window displays messages dealing with Blood Analysis module failures.
The following table describes the messages and corrective actions to take.
If errors occur repeatedly, make a note of the error codes as these can be used for
diagnostic purposes at the factory and must be documented when a module is
exchanged.
7DEOH,1230HVVDJHVIRU%ORRG$QDO\VLV0RGXOH
,1230HVVDJH 3RVVLEOH&DXVH &RUUHFWLYH$FWLRQ
BLOODANL
UNPLUGGED
Blood Analysis module has been
unplugged from the rack.
Perform Step 3 on page 5-24.
BLOODANL EQU.
MALF
Permanent malfunction in the
module.
Refer to the related Task Window mes-
sages in Table 5-15 on page 5-26.
BLOODANL CONFIG A configuration problem has
been detected.
Refer to the related Task Window mes-
sages in Table 5-15 on page 5-26.
BLOODANL ROOM
TEMP?
Module environment is too
warm or too cold - operating
range 16 to 30°C (64 to 86°F).
Refer to the related Task Window mes-
sages in Table 5-15 on page 5-26.