User manual

The Configuration Menu

4-4

Table 4-1 Configurable Filters

4. Press the key to move to the next menu item.

The setting for the Setup ID Entry is highlighted.

5. Press (F3) to set the Patient ID entry to Auto or Manual.

If your cardiograph is configured as Auto, the cardiograph will automatically

produce a unique patient ID like 2000040600000001 (YYYYMMD-

DXXXXXXXX), which appears in the Patient ID field. This patient ID will

also appear on the ECG storage screen.

If your cardiograph is configured as Manual entry of patient ID, you must

enter the patient ID using the , , and keys.

6. Press the key to move to the next menu item.

The Set Date and Time menu item is highlighted. The cardiograph uses a

24 hour clock.

7. To select a field on the Date/Time screen, press to move the cursor right or

down, or press to move the cursor left or up until the desired field is high-

lighted.

8. To enter date and time, press F1 to F5 to select the corresponding numbers.

Pressing , causes the numbers that F1 to F5 represent to change from 1-5

to 6-0.

Parameter Choices

a. Default values are shown in boldface type.

Comments

Wander Filter 0.05 Hz

0.15 Hz

0.5 Hz

Select one baseline wander

filter

Noise Filter 40 Hz

100 Hz

150 Hz

Select one noise filter

Artifact Filter On or Off Enable or disable artifact filter

Change