User manual

Connecting the Printer

A-5

Appendix A Setting Up

Your Cardiograph

The connector of the AC/DC Power Adapter provided with the cardiograph

may resemble those for other instrument e.g. printer, modem. Only use the

designated AC/DC Power Adapter (M3952A or M3953A) for the M2662A

cardiograph. Failure to do so may damage the cardiograph or cause human

injury.

The AC/DC Power Adapter supplied with this cardiograph is an integral part

of the cardiograph’s safety features. Using any other AC/DC Power Adapter

may compromise the cardiograph’s safety as well as performance.

8Connecting the Printer

Figure A-4 Connecting the cardiograph to the printer

Please refer to the Agilent PageWriter 10/10i sales literature for printers

recommended for use with the cardiograph.

1. If you are using an infrared adapter, attach it to the parallel port of the printer.

2. Place the printer within 1 m (3 ft) of the M2662A cardiograph.

3. Make sure that the infrared port on the cardiograph (on the left side of the unit as

you are facing it) is pointed directly at the infrared adapter or the built-in infra-

red interface.

WARNING

M2662A Cardiograph

Printer