User`s guide

Setting the Keyboard Mode
PageWriter 200/300pi M1771A/1770A Cardiograph A-9
A
To load the paper:
1. From the front of the cardiograph, release the latch on the left side and
slide the paper door to your left.
2. Remove the outer packaging from the paper stack.
3. Place the paper stack in the compartment so that the top side of the paper
feeds grid side up over the top panel. The paper sensing hole will be in the
lower right corner of the paper.
4. Pull a sheet halfway out and to your left over the paper door. Make sure
that the paper lays on the black roller evenly within the channel of the
paper door. See Figure A-6.
5. Slide the paper door back into place. You will hear a sharp click when the
door is properly latched.
6. If the cardiograph is not on, press the key to turn the unit on.
7. Press to advance the paper to the beginning of the next page.
Setting the Keyboard Mode
The keyboard mode is initially set to lowercase. You can change the keyboard
mode from lowercase to uppercase (and vice versa) by performing the follow-
ing steps.
1. Press the key. The Main Menu appears.
2. Press the key until the Setup Miscellaneous selection is high-
lighted.
OR
3. If your cardiograph is equipped with Options #A05 or StressWriter, press
the key until the Configure the Cardiograph selection is
highlighted. Press the key until the Setup Miscellaneous
selection is highlighted.
4. Press the ( ), or key. The Setup Miscellaneous
menu appears.
5. Press the key to highlight the current keyboard mode.
6. Press ( ) to toggle between UPPER and lower.
On/Standb
y
3DJH
Select
)
Change
)