User`s guide

Restoring the ECG Trace After Defibrillation or Reconnecting Leads
2-12 Recording an ECG
l The key sequence is:
3 lead manual - Custom
⇒
I II III
⇒
aVR, aVL, aVF
⇒
V1 V2 V3
⇒
V4 V5 V6
⇒
Custom ...
6 lead manual - Custom Leads
⇒
Limb Leads
⇒
V1–V6 Leads
⇒
Custom Leads ...
l The key sequence is: 25
⇒
50
⇒
5
⇒
10
⇒
25 ... (numbers
indicate chart speed in mm/sec).
l The key sequence is: 1.0
⇒
1.0 ½V
⇒
2.0
⇒
2.0 ½V
⇒
0.5
⇒
0.5 ½V
⇒
1.0 ...
l The key sequence is an On/Off toggle. When is active,
Filter is displayed on the screen.
Restoring the ECG Trace After Defibrillation or
Reconnecting Leads
After application of a defibrillator pulse, reconnecting one or more leads, or
any other time the ECG signal is off-center during a Manual report, the trace
can be quickly restored by pressing the key.
Recording an Auto ECG
To record an Auto ECG, perform the following steps.
1. If the cardiograph is not On, press .
2. Prepare the patient and apply the electrodes.
3. Check the signal quality on all leads.
4. Enter patient ID information, if necessary.
5. The leads recorded by the Auto ECG, the chart speed, sensitivity, and
filter status can be changed before the Auto ECG starts. To change these
settings simply select , , , , or keys, as
appropriate.
l The key sequence is: 3x4 ⇒ 3x4 1R ⇒ 3x4 3R ⇒ 6x2 ⇒ 3x4
...
Leads
Speed
Size
)LOWHU
)LOWHU
0DQXDO
2Q6WDQGE\
Format Leads Speed Size
)LOWHU
Format