Technical data

Agilent Signal Generators Programming Guide 27
Using IO Interfaces
Using GPIB
Set Up the GPIB Interface
For the Agilent MXG refer to the Figure 2- 1 and for the ESG and PSG, Figure 2- 2 on page 28.
Figure 2-1 Setting the GPIB Address on the Agilent MXG
Agilent E2078A HP–UX 10.20 VISA/SICL ANSI C,
Agilent VEE,
Agilent BASIC,
HP–UX
PCI 750 Built–in
a.Windows 95, 98(SE), NT, 2000, and XP are registered trademarks of Microsoft Corporation.
b.Windows 98 and ME are registered trademarks of Microsoft Corporation.
c.NI–488.2 is a trademark of National Instruments Corporation.
Interface
Type
Operating
System
IO Library Languages Backplane/
BUS
Max IO
(kB/sec)
Buffering
Agilent USB/GPIB Interface Converter for PC–Based Systems
For details on each key, use the key help. Refer to “Getting Help (Agilent MXG)” on page 20 and the User’s Guide. For additional SCPI
command information, refer to the SCPI Command Reference.
Default address: 19
Range: 0–30
SCPI commands:
:SYSTem:COMMunicate:GPIB:ADDRess <number>
:SYSTem:COMMunicate:GPIB:ADDRess?