User`s guide

To transfer the setup of an entire test sequence
The HP 54653A ScopeLink software 2.0 can transfer an entire test sequence
from the oscilloscope to the PC and store it as a file. The file can be used as a
backup of the test sequence. To restore the test sequence, simply send the
file back to the oscilloscope. The file can also be used for duplication of a
test sequence to other HP 54600-series oscilloscopes.
1 Select Data Transfer from the menu bar, then select Test
Automation.
2 When the Test Automation Panel appears, check the box labelled All
for transferring the whole test sequence.
3 Enter the filename into the Filename box.
The extension of the filename must be ".SLA", which is automatically
appended to the filename if no extension is given.
4 To retrieve the test sequence, check the box labelled Receive. To
send the test sequence, check the box labelled Send.
5 Select Okay to start the transfer. To return to the main menu, select
Quit.
The progress of transfer is displayed. Over HP-IB, it takes about twenty
seconds to complete a transfer. Over RS-232 with a baud rate of 9600, it
takes about 2 minutes to complete a transfer.
After the transfer of the test sequence from the oscilloscope to the PC is
completed, it is saved to the file specified in the Filename box.
HP 54653A ScopeLink 2.0 Software
To transfer the setup of an entire test sequence
112