User`s guide

To backup and duplicate sequences
To duplicate a sequence from one oscilloscope to another, or to backup a
sequence, you must use an instrument controller. The instrument controller
can read the learn string of the entire sequence setup from an oscilloscope
and save it in memory or write it to another oscilloscope. See chapter 4,
"Test Sequencing Programming" for information on reading the learn string
and sending it to another oscilloscope.
The HP 54653A ScopeLink 2.0 software supports the backup and duplication
of sequences as well. See chapter 6, "HP 54653A ScopeLink 2.0 Software" for
detailed information.
Module operating hint
All the configuration of the sequences including the masks are stored inside
the nonvolatile memory in the module. The module can be detached from one
oscilloscope and attached to another oscilloscope of same model without
losing any configuration. In some situations, you can even carry multiple
modules with you, each having a different test sequence for a particular test.
Then you can easily change the modules to configure the oscilloscope for
different testing tasks.
Operating the Test Automation Module
To backup and duplicate sequences
57