Specifications

Table 1. Softkey Descriptions (6 of 17)
Key Name
Delete
fnstr.
Delete
Point
Detect
Const
DONE
Down
Convert
DUT
DUT Source
Enter State
EFC/DCFM
Eval Allan
Eval.
Caldata
Description
Allows you to delete an instrument from the System
Configuration Table.
Removes a point form the Spec-Line Table in the
Define Graph display.
Steps through the calibration methods available on
the Calibration Process display for calibrating the
Phase Detector Constant.
Returns operation to the previous display.
Configures a Down Converter into the Source Control
Diagram. The System Control softkey is enabled for
this function when the HP 11729C is selected.
The Device Under Test configured in the Source
Control Diagram. This softkey allows you to define
the DUT for your measurement.
Configures the signal source in the Source control
Diagram for an FM Discriminator measurement.
Similar to Send command softkey found under
11848A Control; however, switches are now changed
in the HP 11848A. (This is for a simulation only.)
Configures the Tune Voltage path in the Source
Control Diagram for the DCFM port or the EFC port
(Electronic Frequency Control).
Solves the Allan Variance for Sigma of Tau.
Accesses a routine that allows you to display the
response of a specific calibration path.
Chapter
6 System
Configuration
2 Meas.
Definitions
2 Meas.
Definitions
None
2 Meas.
Definitions
2 Meas.
Definitions
2 Meas.
Definitions
5 Special
Functions
2 Meas.
Definitions
4 Computed
Outputs
5 Special
Functions
Softkey Index 9