Technical data

Testing Performance 2

7000 Series Oscilloscopes Service Guide 23

List of Test Equipment

Below is a list of test equipment and accessories required to

perform the performance test verification procedures.

Table 1 List of test equipment

Equipment Critical Specifications

Recommended Model/

Part Number

Test connector, 8-by-2* See page 26 for instructions on building test connector. n/a

Digital Multimeter 0.1 mV resolution, 0.005% accuracy Agilent 34401A

Power Splitter Outputs differ by 0.15 dB Agilent 11667B

Oscilloscope Calibrator DC offset voltage of -5.5 V to 35.5 V, 0.1 V resolution

25 MHz—500 MHz sine wave, 5 ppm

Fluke 5820A

Signal Generator 25 MHz, 100 MHz, 350 MHz, 500 MHz, and 1 GHz

sine waves

Agilent N5181A,

E4400B, or 8648A

Power Meter & Sensor 1 GHz

±3% accuracy Agilent E4418B & 8482A

BNC banana cable BNC (m) to dual banana Pomona 2BC-BNC-36 or

Agilent 11001-66001

BNC cable (qty 3) BNC - BNC, 48” length Agilent 10503A

†

Cable Type N (m) 609.6 mm (24 in.) Agilent 11500B

Probe cable* No substitute Agilent 01650-61607

†

Agilent 54620-68701

Adapter BNC(f) to banana(m) Agilent 1251-2277

†

Adapter BNC Tee (m) (f) (f) Agilent 1250-0781

†

Pomona 3285

Adapter Type N (m) to BNC (m) Agilent 1250-0082 or

Pomona 3288 with

Pomona 3533

Blocking capacitor and shorting cap Note: if a BNC blocking capacitor is not available use an

SMA blocking capacitor.

Agilent 10240-70001 +

Agilent 1250-0774 or

Agilent 11742A +

Pomona 4288 +

Pomona 5088A

Adapter (qty 3) N(m) to BNC(f) Agilent 1250-0780

7000 service guide.book Page 23 Thursday, October 16, 2008 12:18 PM