Technical data

Demo Board Getting Started Guide
12 Agilent InfiniiVision 7000B Series Oscilloscopes Evaluation Guide
4 Vertical Controls:
a Turn the large
yellow knob in the
Vertical section to
control the V/div
setting. The V/div
setting is displayed
in the upper left
hand corner of the
status line at the
top of the display.
Knobs are color
coded to match the
waveform color.
b Press the [1] key to
display the
channel 1 menu. Press again to turn the channel on and off.
c Turn the small yellow knob to control the offset position of the
waveform, moving it up or down.
5 Trigger Controls:
a Rotate the Trigger Level knob to
move the trigger level up and
down. The trigger level is
displayed while it is adjusted. If
the trigger level is above or
below the signal, the
oscilloscope will force a trigger and display a waveform when in Auto
mode. Auto is a useful trigger mode to use, when unsure of the exact
waveform, because activity will be displayed making it easy to better
configure the oscilloscope’s settings and trigger level.
b Press the [Mode/Coupling] key in the Trigger controls section to
view the coupling menu selections and to set trigger holdoff.
c Press and hold the Mode softkey to read more about the Auto and
Normal trigger mode using the built-in help system.