Technical data


18
Agilent InfiniiVision 7000B Series Oscilloscopes
Evaluation Guide
2
Using Auto Scale, Cursors,
Measurements, and Waveform Math
In this lab, we use some of the automatic set up and measurement
capabilities of the Agilent InfiniiVision Series oscilloscope including Auto
Scale, cursor measurements, automatic parametric measurements, and
waveform math functions.
Setup
1 Connect the demo kit’s 40-pin ribbon cable from the back of the Agilent
InfiniiVision Series oscilloscope to the 40-pin connector on the demo
board.
2 Connect channel 1 probe to the CH1 test point and ground (GND).
3 Connect channel 2 probe to the CH2 test point and ground (GND).
4 Set the rotary switch on the demo board for the AM signal (Mode #1).
5 Press [Default Setup].
6 Press [Auto Scale].
7 Push the Waveform Intensity knob to
set the waveform intensity at 50%.