User`s guide

Operating the DC Power Analyzer 3

Model N6705A User’s Guide 55

Scope View

Press the Scope View key to view the scope. This key toggles between

the Standard view shown below, and Marker view, which enables

markers and marker calculations. Whenever the Scope View is

displayed, the measurement system continuously measures the

specified output voltage or current signals.

You can configure the Scope View to display voltage or current

waveforms for all outputs. Power waveforms can only be displayed

for Agilent Models N6761A and N6762A as these models have

simultaneous voltage and current measurement capability. Note that

in the Scope View there is only one time-base and trigger

configuration for all outputs.

Standard View

Symbol/Field: Description:

1 Trace Controls

Identifies the volt/div. or curr/div. setting of the trace. √ indicates

the trace is on. ---- indicates the trace is off. Select the trace and

press Enter to turn it on or off.

2 Data Bar

The data bar represents all of the waveform data that has been

collected. The yellow part of the bar indicates the portion of the data

that is actually shown on the display The dark portion of the bar

represents the data not shown.

3 Voltage Traces

Labels for the voltage traces appear on the left side of the grid (V1,

V2, V3, V4). Traces are color coded according to output.

Push the Trigger Level knob to autoscale the traces.

4 Trigger Point

Offset Reference

Shows the position of the trigger with respect to the captured

waveform. In this example, the trigger has been offset to the left of

the original point. The trigger point corresponds to the offset

reference when the offset is zero.

Indicates the original trigger reference point. In this example, the

reference is centered.