User`s guide

Key Reference 4
N9320A Spectrum Analyzer 85
Test
On Off
Toggles the testing of the limit lines
between on and off. If trace 1 is at or
within the bounds of the set limit or
margin, “Limit_# Pass” or “Margin_# Pass” is
displayed in the upper left corner of the
measurement area limit line. Only
positive/negative margins are allowed for
lower/upper limits. If the trace is out of
the limit or margin boundaries, “Limit_#
Failed” or “Margin_# Failed” is displayed.
Either Limit or Margin must be turned on
for test.
Key access:
> Limits > Limit 1/2
Margin
On Off
Toggles the margin function to on or off.
Use Margin to set a limit line offset for
the selected limit line. Either Limit or
Margin as well as Test , must be turned on
for a limit test to work.
Key access:
> Limits > Limit 1/2
Edit Accesses the submenu to edit the limit
point, and also accesses the limits table.
Use arrow keys to move between the rows
in the limits table. New limit segments
will only be applied after close the editor.
Pressing Return, or any key not associated
with the editor, will close the editor.
Key access:
> Limits > Limit 1/2
Point
Creates or edit a limit point. Up to 20
points can be defined for each limit line.
Enter the point number using the numeric
keypad, then Press [Enter], or use the
knob or arrow keys to move to an existing
point.
Key access:
> Limits > Limit 1/2 > Edit
Det/
Display
Det/
Display
Det/
Display
Det/
Display