User`s guide

Overview 1
N9320A Spectrum Analyzer 5
8RF INconnector is the signal input for the analyzer. The
maximum damage level is average continuous power
+40 dBm, DC voltage 50 VDC. The impedance is 50 W.
(N- type female).
9 PROBE POWER connector provides power for high- impedance
AC probes or other accessories (+15 V, –12 V, 150 mA
maximum).
10 CAL OUT connector provides an amplitude reference signal
output of 50 MHz at –10 dBm (BNC female).
11 TG SOURCE connector N- type female, is the source output for
the built- in tracking generator. The impedance is 50 W. (for
Option TG3)
12 Standby Switch switches on all functions of the analyzer. To
switch the analyzer off, press the switch for at least 2
seconds. This deactivates all the functions but retains power
to internal circuits so long as the analyzer is connected to
line power.
13 On LED (green) lights when the analyzer is switched on.
14 Standby LED (orange) lights when the analyzer is connected
to the line power.
15 Remote LED (red) lights when the analyzer is remotely
controlled by a PC via the USB host interface on the rear
panel.
16 USB connector (DEV) provides a connection between external
USB devices and the analyzer, such as a USB memory
device.
CAUTION
If the tracking generator output power is higher than the maximum power
that the device under test can tolerate, it may damage the device under
test. Do not exceed the maximum power of DUT.