User`s guide

20 N9320A Spectrum Analyzer
2 Getting Started
Power on and Check
1 Connect the power cord. Insert the plug into a power socket
provided with a protective earth. Set the tilt adjustor for
your preference.
2 Press the line switch on the rear panel. The standby LED
(orange) will light and the spectrum analyzer is in standby
mode.
3 Press the standby switch on the front panel. The Line
LED (green) will light, and the spectrum analyzer boots up.
Self- initialization takes about 25 seconds; the spectrum
analyzer then defaults to the menu mode. After power on,
let the spectrum analyzer warm up for 45 minutes for
stabilization.
NOTE
The front panel switch is a standby switch only; it is not a power
switch. To disconnect the spectrum analyzer from the line power, shut
off the power switch on the rear panel.