User`s guide
Table Of Contents
- Overview
- Getting Started
- System Setting
- Making Measurements
- Measuring Multiple Signals
- Measuring a Low-Level Signal
- Improving Frequency Resolution and Accuracy
- Making Distortion Measurements
- One-button Power Measurement
- Making a Stimulus Response Transmission Measurement
- Measuring Stop Band Attenuation of a Low-pass Filter
- Making a Reflection Calibration Measurement
- Measuring Return Loss Using the Reflection Calibration Routine
- Making an Average Power Measurement
- Key Reference
- SCPI Command Reference
- Error Messages
- Menu Map
![](/manual/agilent-technologies/n9340a/user-s-guide-english/images/img-75.png)
SCPI Command Reference 6
N9340A User’s Guide 117
Separator
• A colon “:” separates keywords of different
hiberarchy.
• A space separates a keyword and a parameter,
as well as a parameter and a unit.
Default unit of parameters
The analyzer has the following default units for
numeric variables.
If you are using the default unit in a command,
you can leave out the unit.
For example, if you are setting the center fre-
quency to 800 MHz of ACPR measurement.
The following two commands have the same effect:
:MEASure:ACPR:CENTer <800000000>
:MEASure:ACPR:CENTer <800 MHz>
Parameter Default unit
Frequency Hz
Absolute amplitude dBm
Time s