User`s guide
Table Of Contents
- Overview
- Getting Started
- System Setting
- Making Measurements
- Measuring Multiple Signals
- Measuring a Low-Level Signal
- Improving Frequency Resolution and Accuracy
- Making Distortion Measurements
- One-button Power Measurement
- Making a Stimulus Response Transmission Measurement
- Measuring Stop Band Attenuation of a Low-pass Filter
- Making a Reflection Calibration Measurement
- Measuring Return Loss Using the Reflection Calibration Routine
- Making an Average Power Measurement
- Key Reference
- SCPI Command Reference
- Error Messages
- Menu Map
6 SCPI Command Reference
154 N9340A User’s Guide
Reference Trace
:TGENerator:NORMalize:TRACe VIEW|BLANk
:TGENerator:NORMalize:TRACe?
This command toggles the reference trace display
between VIEW and BLANk.
VIEW means to hold and display the amplitude
data of the selected trace. If a trace is deactivated
by pressing Blank, the stored trace data can be
retrieved by pressing View.
BLANk means to store the amplitude data for the
selected trace and removes it from the display.
*RST State: BLANk
Key Access: {Normalize} > {Ref Trace}