User`s guide
Table Of Contents
- Overview
- Getting Started
- System Setting
- Making Measurements
- Measuring Multiple Signals
- Measuring a Low-Level Signal
- Improving Frequency Resolution and Accuracy
- Making Distortion Measurements
- One-button Power Measurement
- Making a Stimulus Response Transmission Measurement
- Measuring Stop Band Attenuation of a Low-pass Filter
- Making a Reflection Calibration Measurement
- Measuring Return Loss Using the Reflection Calibration Routine
- Making an Average Power Measurement
- Key Reference
- SCPI Command Reference
- Error Messages
- Menu Map
7 Error Messages
158 N9340A User’s Guide
Error Message List
NOTE
A symbol [F] at the beginning of an error message
indicates this is an error caused by manual front
panel operation. A symbol [R] at the beginning of
an error message indicates this is an error caused
by remote control mode.
Error CodeError Message Description
0 No error
–410 Query
INTERRUPTED
Indicates that a condition causing
an INTERRUPTED query occurred
(see IEEE 488.2, 6.3.2.7)
–350 Query overflow
Indicates the SCPI remote interface
error queue overflowed.
–321 Out of memory
Indicates an internal operation
needed more memory than that was
available.
–224 Illegal parameter
value
Indicates you sent a parameter for
this command that is NOT allowed.
–223 Too much data
Indicates a legal program data
element of block, expression or
string type was received that
contained more data than the
device could handle due to related
device-specific requirements or
memory.
–222 Data out of range
Indicates legal data was parsed, but
could not be executed because the
interpreted value was outside the
legal range defined by the analyzer.
The displayed results may be
clipped.
–220 No matched module
Indicates no matched measurement
or mode found.