User`s guide
Table Of Contents
- Overview
- Getting Started
- System Setting
- Making Measurements
- Measuring Multiple Signals
- Measuring a Low-Level Signal
- Improving Frequency Resolution and Accuracy
- Making Distortion Measurements
- One-button Power Measurement
- Making a Stimulus Response Transmission Measurement
- Measuring Stop Band Attenuation of a Low-pass Filter
- Making a Reflection Calibration Measurement
- Measuring Return Loss Using the Reflection Calibration Routine
- Making an Average Power Measurement
- Key Reference
- SCPI Command Reference
- Error Messages
- Menu Map
Getting Started 1
N9340A User’s Guide 19
Preparation for Use
Use the [SYS] hardkey to check or access the sys-
tem settings of your analyzer.
Setting up your N9340A
1 Press [SYS] > {Setting} > {General} to set the time
and power saving mode:
• Press {Time/Date} to set the time and date for
your analyzer.
• Press {Power Manager} to select a power- saving
mode from the following three modes:
2 Press [SYS] > {Setting} > {Language} to select the
language option displayed on screen.
3 To manually adjust the display brightness and
contrast.
• Press [SYS] > {Brightness} and then rotate the
knob to adjust display brightness.
• Press [SYS] > {Contrast} and then rotate the
knob to adjust display contrast.
4 Press [SYS] > {More} > {Key Beep} to toggle the
buzzer beep function between on and off.
Testin g buttons and screen pixel
1 Press [SYS] > {More} > {Diagnostics} > {Front Panel}
to test all the front panel keys except the
[PRESET] hardkey and power switch.
2 Press [SYS] > {More} > {Diagnostics} > {Black Pixel}
or {White Pixel} to test the basic display ability of
the LCD.
• turn off backlight
• turn off screen display
• turn off both backlight and screen display