User`s guide
Table Of Contents
- Overview
- Getting Started
- System Setting
- Making Measurements
- Measuring Multiple Signals
- Measuring a Low-Level Signal
- Improving Frequency Resolution and Accuracy
- Making Distortion Measurements
- One-button Power Measurement
- Making a Stimulus Response Transmission Measurement
- Measuring Stop Band Attenuation of a Low-pass Filter
- Making a Reflection Calibration Measurement
- Measuring Return Loss Using the Reflection Calibration Routine
- Making an Average Power Measurement
- Key Reference
- SCPI Command Reference
- Error Messages
- Menu Map
System Setting 4
N9340A User’s Guide 37
Show Error
Accesses a list of the 30 most recent error
messages as reported by the analyzer. The most
recent error appears at the bottom of the list. If
the error list is longer than 30 entries, the analyzer
reports an error message [–350, Query
overflow]. When in remote control, and the error
list is greater than 30 entries, the error display is
halted and a message at the bottom of the list
informs the user that errors exceed 30.
Key Access: [SYS] > {More} > {Show Error}
For more information, refer to “Error Messages" on
page 157.