User`s guide
Table Of Contents
- Overview
- Getting Started
- System Setting
- Making Measurements
- Measuring Multiple Signals
- Measuring a Low-Level Signal
- Improving Frequency Resolution and Accuracy
- Making Distortion Measurements
- One-button Power Measurement
- Making a Stimulus Response Transmission Measurement
- Measuring Stop Band Attenuation of a Low-pass Filter
- Making a Reflection Calibration Measurement
- Measuring Return Loss Using the Reflection Calibration Routine
- Making an Average Power Measurement
- Key Reference
- SCPI Command Reference
- Error Messages
- Menu Map
Key Reference 5
N9340A User’s Guide 93
In FFT Mode
In FFT mode, the sweep time default is
auto- coupled. The submenu, sweep time, is invalid
in FFT mode.
Sweep
Key access: [BW/SWP] > {Sweep}
Activates the sweep mode function and accesses
the softkey submenus to select the trace sweep
functions.
Sweep
Toggles the analyzer between the continuous sweep
mode and the single sweep mode.
• Sweep (Single)
Puts the analyzer in a single sweep mode. In this
mode, pressing [BW/SWP] > {Single Sweep}
enables a sweep.
Key access: [BW/SWP] > {Sweep}
• Sweep (Cont)
Performs one sweep after another as soon as it
is triggered. Pressing [Preset] (When Preset Type
is set to Default) or turning the power on, sets
the sweep mode to continuous sweep.
Key access: [BW/SWP] > {Sweep}
Sweep Mode
An N9340A provides two sweep modes to meet
different sweep time requirements:
•Normal
Activates the default sweep mode.
Key access: [BW/SWP] > {Sweep} > {Sweep Mode}