Technical data

154 Programmer’s Guide
5 Command Reference
Channel Scanner Edit Subsection
Set Channel Edit Method for List Sweep
:CHSCanner:EDIT:LIST:METHod
<index>,<0|1>{,<index>,< 0|1>}
:CHSCanner:EDIT:LIST:METHod?
This command specify the channel edit method for list sweep. In list
sweep mode, there are two method to insert or edit a scan channel,
custom method and signal standard method. Custom method requires to
insert or edit a scan channel by inputting the center frequency and
bandwidth of channel, and signal standard method requires to choose
the signal standard and channel ID from built-in signal standard list.
Remarks: Parameter <0|1> indicate <Custom | Standard>
Example: :CHSCanner:EDIT:LIST:METHod 1,0,3,1
Key access: Meas > List Edit > Insert > Edit Method
Add Channel By Custom For List Sweep
:CHSCanner:EDIT:LIST:ADD:CUSTom
<freq>,<bandwidth>{,<freq>,<bandwidth>}
This command adds custom scan channels to the sweep list of List
Sweep Mode.
Example: :CHSCanner:EDIT:LIST:ADD:CUSTom
10000000,1000000,20000000,10000
Key access: Meas > List Edit > Insert > Edit Method > Custom
Add Channel By Signal Standard for List Sweep
:CHSCanner:EDIT:LIST:ADD:STD <signal std.>,<ch.
no>{,<signal std.>,<ch. no>}
This command adds scan channels according to the build-in signal
standard. The address of build-in signal stand file is “d:/”.
Example: :CHSCanner:EDIT:LIST:ADD:STD
"d:/CDMA-AWS_DL.STD,11"
Key access: Meas > List Edit > Insert > Edit Method Std > Signal Std