user manual

Chapter 1 49

Instrument Messages

651 Connect RF OUT to INPUT

Attempt to align the tracking generator without its output connected.

Connect the tracking generator RF OUT to the analyzer

INPUT.

652 Connect Amptd Ref Output to Input

For Agilent Technologies E4402B, E4403B, E4404B, E4405B, E4407B, and

E4408B only: you must connect the

AMPTD REF OUTPUT to the analyzer

INPUT with the appropriate cable.

653 Auto Align not available when using Calibration Defaults

The Auto Alignment system cannot be used until an Align Now All is

executed by pressing

System, Alignments, Align Now, All. On all Agilent

Technologies ESA spectrum analyzer models except Agilent Technologies

E4401B and E4411B, you must connect the

AMPTD REF OUT to the INPUT

with the appropriate cable to perform this alignment. For Agilent

Technologies E4401B and E4411B only: disconnect any signals from the

INPUT prior to performing this procedure.

701 Invalid printer response

In attempting to identify the printer an invalid response was received.

Check that you are using a supported printer. Be sure you are using the

proper cable and that it is securely fastened.

702 Unsupported printer

A printer which is recognized, but known to be unsupported was

identified. This printer cannot be used with the analyzer. For example, a

printer only supported by Microsoft Windows will generate this error.

703 Unknown printer

In attempting to identify the printer, a valid response was received but the

printer is not known to the analyzer. Use the

Custom printer menu under

Print Setup to configure the printer.

704 Printer interface error

An error occurred while trying to print. Make sure the printer is turned on

and properly connected.

705 Printer Type is None

The current printer type is set to

None, so no print operations are possible.

Change the type in the

Print Setup menu and try again.

727 In <filename>: [DATA] header missing

This message indicates that the data section of a file did not begin with the

token [

DATA].