User`s guide

U1273A/U1273AX Handheld Digital Multimeter
Install the Batteries
2 U1273A/U1273AX Quick Start Guide
Install the Batteries
Your multimeter is powered by four 1.5 V AAA batteries
(included with the shipment).
1 Turn the rotary switch to OFF and remove
the test leads from the terminals.
2 Lift the tilt stand and loosen the screws
with a suitable Phillips screwdriver.
3 Remove the battery cover and observe the
polarity markings.
4 Insert the batteries and replace the battery cover and screws.
Turn On the Multimeter
To power ON your multimeter, turn the rotary switch from the
OFF position to any other position.
Auto Dim
By default, the multimeter’s Auto Dim function is enabled. The
multimeter’s backlight will dim automatically after 90 seconds
of inactivity. Press any button to cancel this effect and reset
the Auto Dim timer.
You may change how the multimeter’s backlight behavior
through the Setup menu. Refer to the User’s Guide for further
instructions.
NOTE
Your multimeter is capable of remote data logging. To use this
feature, you will need an IR-USB cable (U1173A, purchased
separately) and the Agilent GUI Data Logger Software (down-
loadable from www.agilent.com/find/hhTechLib).