User`s guide

U1731C/U1732C/U1733C User’s Guide XV
List of Figures
Figure 1-1 Installing the batteries 4
Figure 1-2 Power-on button 5
Figure 1-3 Tilt-stand adjustment and IR cable connection 8
Figure 1-4 Agilent GUI Data Logger Software 9
Figure 1-5 Width dimensions 11
Figure 1-6 Height and depth dimensions 12
Figure 1-7 Front panel 13
Figure 1-8 Rear panel 14
Figure 2-1 Using the Ai function 26
Figure 2-2 Inductance measurement with Q factor 29
Figure 2-3 Measuring inductance 30
Figure 2-4 Capacitance measurement with D factor 31
Figure 2-5 Measuring capacitance 32
Figure 2-6 Resistance measurement 33
Figure 2-7 Measuring resistance 34
Figure 2-8 Impedance measurement with theta 35
Figure 2-9 Measuring impedance 36
Figure 2-10 Component above setting tolerance 38
Figure 2-11 ESR measurement with theta 39
Figure 2-12 DCR measurement 39
Figure 2-13 Using the Hold function 40
Figure 2-14 Using the Rec function 41
Figure 2-15 Using the Limit function 43
Figure 2-16 High and low limit values 44
Figure 2-17 nGo and Go indications 44
Figure 2-18 Using the Null function 45
Figure 2-19 Using the Cal function 47
Figure 2-20 Open calibration and short calibration prompts 48
Figure 3-1 Changing the power-on measurement type 57
Figure 3-2 Changing the power-on test frequency 58
Figure 3-3 Changing the power-on secondary parameter and
measurement mode for inductance (L)
measurements 59
Figure 3-4 Changing the power-on secondary parameter and
measurement mode for capacitance (C)