Assembly Instruction

MODEL # 50-46490-487
IMPORTANT NOTE: Your sling seat may appear to be slightly warped. This is not unusual.
Proper assembly procedure will straighten out the sling seat in the frame. There are four bolts
used to attach the seat frame to the seat base. After inserting all the bolts, each of these bolts
must be tightened a few revolutions at time in rotation.
Set parts on a flat, non-abrasive surface to avoid scratching. If you are
missing any parts or are unsure how to proceed with assembly, call our Customer
Service Center immediately at 1-800-416-3511. Do not attempt to assemble chair
if any parts are missing or damaged.
IMPORTANT NOTE: Assembling this chair requires attaching the sling seat frame to the
seat base. We recommend two people work together to assemble the chair since it is critical
that all the holes in the seat frame are aligned exactly with the holes in the seat base. All bolts
need to be inserted and tightened into the fixed nuts in a straight and direct path. Inserting the
bolts at even the slightest angle could strip the nuts and bolts, damaging the entire chair.
that the holes on both
sides of the upper portion of the seat frame back align with the fixed nut holes in the seat base.
Step 3: From behind the chair, i
exactly straight! Hand tighten 3-4 revolution only. DO NOT TIGHTEN
COMPLETELY.
Working from the front of the chair, a (1/4"x45mm). From the underside
of the front seat support bar, insert bolt with washer
COMPLETELY. Repeat for opposite side.
top left bolt. Move to bottom right bolt then to top right bolt, followed by bottom left bolt.
Repeat this “X” pattern until all bolts are tight. DO NOT OVER TIGHTEN BOLTS. Over
tightening may strip bolts or nuts, damaging the entire chair.
Step 6: Examine the chair from the front. If the sling seat does not appear tight or straight in the
seat base, repeat steps 3, 4 and 5. If you do not feel your chair is assembled properly,
or you have any questions, call our Customer Service Center at 1-800-416-3511.
Step 1: Identify all parts packed in the carton against the parts list. Remove all protective
materials.
Step 2: Working from behind the chair, have another person stand in front of the chair and position
the sling seat frame in between the arms of the seat base (as shown) so
nsert a bolt (1/4"x35mm) through the hole on one side of upper portion
of the seat frame and into the fixed nut in the back arm portion of the seat base. Make sure the
bolt is inserted
Repeat for opposite side of chair.
Step 4: dd a washer to a bolt
through one of the holes in the seat support
bar, into the fixed nut inside the lower front portion of the seat frame. Hand tighten 3-4
revolutions only. DO NOT TIGHTEN
Step 5: Tighten all bolts. Each bolt must be tightened a 3-4 revolutions only at a time. Begin with
Page 2
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION SHEET BEFORE ASSEMBLY!!
PARTS LIST
QTY. / PCS
DESCRIPTION
1/4"x35MM BOLT
1/4"x45MM BOLT
WASHER
HEX BOLT DRIVER
HEX WRENCH
2
1
SEAT BASE
SEAT FRAME
1
1
1
2
2
1
2
3
4
5
6
7
4
3
3
4
FRONT SEAT SUPPORT BAR