User's Manual

18 AGM Global Vision

1. Remove every screw (A) along with the upper parts (B) of the

scope rings.

2. Loosen the fixing screws (C) of the lower parts (D) of the rings and

install them on the rail.

3. Then, you can try to fit the scope before placing the upper rings.

The scope rings need to be at a proper distance from the objective

bell as well as the turrets so that the eye relief adjustment can be

done.

4. You can insert a thread locker and tighten the fixing screws of the

lower parts of the rings.

5. Place the upper rings and slightly fixing them with the screws only

enough to allow the scope to rotate and move back and forth.

6. Adjust the eye relief. Position the scope far enough to keep your

eye safe from recoil.

7. Turn on the power of the scope and activate the reticle.

8. With the rifle held level, rotate the scope until the reticle is

precisely vertical and horizontal.

9. Сheck the position of the scope and tighten the ring screws.

Ensure an even fit by alternately tightening the screws.

2.1.16 INSTALLING THE HORUS ON A PICATINNY/

WEAVER RAIL WITH QUICK RELEASE MOUNT

You can mount the Horus scope on a Picatinny/Weaver rail of

weapon using quick release (QR) mount (Figure 2-7).

1. Unlock the clamping devices of the QR mount by pushing down on

the lever holders (A) and unlocking the levers (B).

2. Install the mount on the Picatinny/ Weaver rail so that the stops

FIGURE 2-6. INSTALLATION WITH SCOPE RINGS

D C