User's Manual

27HORUS USER MANUAL
6. You can boresight the scope by moving the reticle on screen. Set
the reticle position as folows:
1) Aim the big reticle at the target.
2) (Optional) Rotate the wheel to select Zoom, and press the
wheel to switch the zoom ratio.
3) Rotate the wheel to select the coordinates, and press the wheel
to switch the X and Y axis.
4) Rotate the wheel to move the reticle until it reaches the target
position. The small reticle indicates the initial position of the
reticle.
7. (Optional) Repeat 3 to 6 to set the position for other reticles in
this group.
NOTE
When you switch the reticle number, a prompt will appear on the
interface. Select OK to save the parameters for the current reticle.
8. Hold the wheel button to exit the interface according to the
prompt:
– OK: Save the parameter and exit.
– Cancel: Exit but not save the parameters.
TABLE 2-5. BORESIGHT CORRECTIONS
MODEL
ADJUSTMENT
VALUE
RETICLE
OFFSET
BORESIGHT INCREMENT
HORUS
1 click 1 pixel
0.09 mil / 0.31 MOA /
0.9 cm at 100 m distance /
0.32 in at 100 yd distance
2.2.9 SHOT ACTIVATED RECORDING (SAR)
After enabling SAR function, the device can automatically record the
7 seconds before the recoil-activation and the 7 seconds after the
recoil-activation.
1. In the main live view, hold the wheel to show the menu.
2. Rotate the wheel to select
PRERECORD menu item.
3. Press the wheel button to switch the on/off mode Prerecord
Video function.
4. Hold the wheel button to save and exit.